Tineco iFloor Y2 Plus Smart Wet & Dry Cordless Vacuum Floor Washer & Mop Stick—

Clean smarter, not harder. The iFloor Y2 Plus vacuums and mops sealed hard floors in one seamless step. Its anti-tangle brush roll and self-cleaning system keep maintenance low, while a dual-tank system delivers up to 30 minutes of cordless cleaning — perfect for busy homes and pet owners.

• iFloor Y2 Plus Smart Wet & Dry Cordless Vacuum Floor Washer & Mop Stick
• Vacuums and mops sealed hard floors in one step
• Anti-tangle brush roll prevents hair clogs
• One-touch self-cleaning flushes brush and tubes
• Dual tanks for clean (1L) and dirty (0.8L) water
• Up to 30 minutes cordless runtime
• Lightweight and easy to manoeuvre
• Enhanced edge cleaning reaches baseboards and corners
• Ideal for small to medium homes and apartments
• Pet-friendly with powerful suction and tangle-free operation

What’s in the box?

• 1 x iFloor Y2 Plus Smart Wet & Dry Cordless Vacuum Floor Washer & Mop Stick
• 1 x Docking station
• 1 x Charger cable
• 1 x Roller brush
• 1 x Cleaning tool
• 1 x Sample cleaning solution

About Tineco

Founded in 1998, Tineco dedicates itself to the engineering of premium household electronics that are helpful, easy to use, and smart. With over two decades of experience in the home cleaning industry, Tineco never stops innovating and is ready to create an easy smart life for everyone.

• Dimensions: 112.5cm L x 26.5cm W x 27.5cm D
• Weight: 4.3kg
• Material: Plastic
• Colour: White & Orange
• Runtime: Up to 30 minutes
• Charging time: 5 h
• Battery: 25.2 V
• Motor power: 140 W
• Water tank capacity:
• Clean water tank: 1L
• Dirty water tank: 800ml
• Brush type: Anti-Tangle Roller
• Self-cleaning: Yes (One-touch system)
• Edge cleaning: Enhanced side reach
• Suitable surfaces: Sealed hard floors – tile, vinyl, laminate, hardwood
• Noise level: ≤78dB
• Power supply: Rechargeable internal battery

• Daily cleaning routine:
  • Switch off before maintenance
  • Empty and rinse the Dirty Water Tank (DWT), remove after use, empty contents, rinse thoroughly and allow to dry
  • Clean the pre-filter, floater and sponge, remove from tank lid, rinse under running water and ensure all parts are fully dry before reassembly
  • Clean Water Tank (CWT) management:
  • Refill the CWT with tap water up to the max line, max 60 °C (140 °F), do not use boiling or distilled water
  • Add cleaning solution only when deep cleaning is needed, one capful per full CWT
  • Never use acidic, alkaline, or non-approved chemicals
• Brush roller & self‑cleaning:
  • Self-clean the brush roller after use by placing the unit on the storage tray, plugging in the adapter, pressing and holding the power button for 3 seconds to start the cycle, ensure the CWT is at least one-third full before starting
  • Manually clean the brush roller regularly by removing the roller, using the cleaning tool to remove hair and debris, rinsing thoroughly, and allowing it to air-dry before reinstalling
• Maintenance of external surfaces:
  • Wipe the main body with a dry cloth and mild detergent to keep surfaces clean and prevent water ingress
• Charging & storage:
  • Charge fully before first use and as needed, a full charge typically takes 4–5 hours
  • Store the unit indoors in a dry place at temperatures between 4 °C and 40 °C
  • During extended inactivity, recharge every three months to preserve battery health
• Troubleshooting & best practices:
  • Check for blockages or saturation if suction weakens, spray stops, or indicator lights blink, empty and clean the DWT and filters first
  • Avoid excessive liquids, foam, or unsuitable cleaning agents to prevent motor damage or sensor blockage

This product comes with a 2-year warranty against manufacturing defects.