Tineco iFloor Y2 Plus Smart Wet & Dry Cordless Vacuum Floor Washer & Mop Stick

Clean smarter, not harder. The iFloor Y2 Plus vacuums and mops sealed hard floors in one seamless step. Its anti-tangle brush roll and self-cleaning system keep maintenance low, while a dual-tank system delivers up to 30 minutes of cordless cleaning — perfect for busy homes and pet owners.

• iFloor Y2 Plus Smart Wet & Dry Cordless Vacuum Floor Washer & Mop Stick
• Vacuums and mops sealed hard floors in one step
• Anti-tangle brush roll prevents hair clogs
• One-touch self-cleaning flushes brush and tubes
• Dual tanks for clean (1L) and dirty (0.8L) water
• Up to 30 minutes cordless runtime
• Lightweight and easy to manoeuvre
• Enhanced edge cleaning reaches baseboards and corners
• Ideal for small to medium homes and apartments
• Pet-friendly with powerful suction and tangle-free operation

What’s in the box?

• 1 x iFloor Y2 Plus Smart Wet & Dry Cordless Vacuum Floor Washer & Mop Stick
• 1 x Docking station
• 1 x Charger cable
• 1 x Roller brush
• 1 x Cleaning tool
• 1 x Sample cleaning solution

• Dimensions: 112.5cm L x 26.5cm W x 27.5cm D
• Weight: 4.3kg
• Material: Plastic
• Colour: White & Orange
• Runtime: Up to 30 minutes
• Charging time: 5 h
• Battery: 25.2 V
• Motor power: 140 W
• Water tank capacity:
• Clean water tank: 1L
• Dirty water tank: 800ml
• Brush type: Anti-Tangle Roller
• Self-cleaning: Yes (One-touch system)
• Edge cleaning: Enhanced side reach
• Suitable surfaces: Sealed hard floors – tile, vinyl, laminate, hardwood
• Noise level: ≤78dB
• Power supply: Rechargeable internal battery

• Power connection: Cordless rechargeable

• Daily cleaning routine:
  • Switch off before maintenance
  • Empty and rinse the Dirty Water Tank (DWT), remove after use, empty contents, rinse thoroughly and allow to dry
  • Clean the pre-filter, floater and sponge, remove from tank lid, rinse under running water and ensure all parts are fully dry before reassembly
  • Clean Water Tank (CWT) management:
  • Refill the CWT with tap water up to the max line, max 60 °C (140 °F), do not use boiling or distilled water
  • Add cleaning solution only when deep cleaning is needed, one capful per full CWT
  • Never use acidic, alkaline, or non-approved chemicals
• Brush roller & self‑cleaning:
  • Self-clean the brush roller after use by placing the unit on the storage tray, plugging in the adapter, pressing and holding the power button for 3 seconds to start the cycle, ensure the CWT is at least one-third full before starting
  • Manually clean the brush roller regularly by removing the roller, using the cleaning tool to remove hair and debris, rinsing thoroughly, and allowing it to air-dry before reinstalling
• Maintenance of external surfaces:
  • Wipe the main body with a dry cloth and mild detergent to keep surfaces clean and prevent water ingress
• Charging & storage:
  • Charge fully before first use and as needed, a full charge typically takes 4–5 hours
  • Store the unit indoors in a dry place at temperatures between 4 °C and 40 °C
  • During extended inactivity, recharge every three months to preserve battery health
• Troubleshooting & best practices:
  • Check for blockages or saturation if suction weakens, spray stops, or indicator lights blink, empty and clean the DWT and filters first
  • Avoid excessive liquids, foam, or unsuitable cleaning agents to prevent motor damage or sensor blockage

This product comes with a 2-year warranty against manufacturing defects.